Convert to Electric - Manual Feed Gate Spreader Troubleshooting

Not sure if this is your device? This article is for the Food Plot Spreader (SKU/Product #: MFHP53880). 
Double-check this info or click here to visit our "Identify My Device" page before you continue.

Troubleshooting

Please see the below instructions on how to convert your Manual Feed Gate Spreader to an Electronic Feed Gate Spreader.

Purchase these parts:

• Electronic Feed Gate
• Electronic Feed Gate Wire Harness

Once you have the needed parts, do the following:

1. Remove the Feed Gate & Linkage, the Stiffener, the Lever Arm, and the Wire Harness.
2. Install the Electronic Feed Gate and the Electronic Feed Gate Wire Harness.
   1. For installation instructions, utilize the manual by clicking here.
   2. Please note that the Manual and Electronic Feed Gate Spreaders have different holes in their hoppers. See the below picture of the Electronic Feed Gate Spreader Hopper. You can either drill the needed holes or you can purchase the Electronic Hopper by clicking here.

c.