Not sure if this is your device? This article is for the All-In-One feeder kit (SKU/Product #: MFHP12367 & MFP80096). 
Double-check this info or click here to visit our "Identify My Device" page before you continue.

Note: This article is for the setup of the feeder kit itself, not the hopper assembly. For hopper assembly instructions, go back a section & select our Hopper Setup section.

Getting Started

Congratulations! Now that you have your All-In-One feeder kit, continue reading to learn how to get it up and running! 

1 POSITION TIMER:

The timer may be rotated outward for easier viewing. Gently pull down on the button-side of the timer as shown.

2 SET TIME OF DAY:

Press the UP or DOWN button until the correct time of day appears. Press and release button to single-step through the minutes or hold down to advance quickly.

3 SET FEED TIMES:

Press the SET button until the correct timer number appears as shown. Press the UP or DOWN button to set the Feed Time.
Note: Factory settings are 7am and 6pm.

4 SET RUN DURATION:

Press the SET button again to set the RUN-TIME SECONDS which can range from zero to twenty seconds. Adjust RUN-TIME SECONDS as needed. Set the RUN-TIME SECONDS to zero to disable the specific feed time.
Note: Factory setting is 6 seconds.

TEST FEEDER:

PRESS AND HOLD the SET button while the RUN-TIME SECONDS are displayed. Release the button and get away from the feeder when the message “TESTING GET AWAY” appears on the display.