Moultrie Trail Cameras use a passive infrared (PIR) sensor to detect when an object passes in front of it. When the PIR sensor is triggered the camera takes a photo. At times, the PIR sensor will trigger and there won't be anything in the photo. These are called “False Triggers” and could be the result of placing the camera in an environment where tree branches, grass, leaves, etc., are blowing in the wind and creating motion. Sunlight can also cause false triggers as the PIR sensor is reading the sunbeam as hotter than the surrounding environment. Setting a camera up over water is also a potential cause of this issue. Follow these tips to reduce or eliminate false triggers on your Moultrie Trail Camera.
1. Check how your camera is mounted.
Ensure that if your camera is strapped to a tree, the tree is large enough to not sway in the wind as this can cause a false trigger.
2. Position your camera facing north or south. North is best.
If you position your camera aiming east or west your camera tends to have a greater frequency of false triggers due to the rising or setting sun passing through it's frame.
3. Place your camera at the right height.
Mount the camera to a strong tree or camera stand positioned 3 to 5 feet off the ground. Attaching your camera too low can result in getting too many pictures of small non-targeted creatures. Placing your camera too high and facing downward can cause the camera to pick up shadows and changes in ground temperature. Please be advised, oftentimes there can be smaller animals in the brush that you cannot see, but your camera is able to detect.
4. Clear all vegetation from in front of the camera.
Any grasses, small limbs or twigs growing out of the ground in front of the camera can cause a false trigger.
5. Check your camera’s settings.
Double-check that your camera’s PIR sensitivity is set to low and ensure that you aren’t set to multi-shot mode. Refer to your camera's manual for all your settings options.
6. Perform a Test.
If the troubleshooting above does not correct the issue, then perform a test to verify your camera is taking pictures without being triggered by doing the following:
-
Prepare a Test Box
- Find a closed box large enough to hold the camera with some extra space around it.
- Ensure the box is solid (not see-through) and has a lid that can fully close.
-
Set Up the Camera in the Box
- Place the camera upright with its back against one wall, facing the longest stretch inside the box.
- Ensure that your camera's upload frequency is set to "Immediate" upload
- If it is not, change it now via the device's settings page.
-
Turn On the Camera
- Power on the camera, ensuring it’s set up as you would for regular use.
-
Close the Box
- Seal the box by closing the lid securely.
- Place the box in a location where it will not be disturbed.
-
Wait for the Test to Run
- Leave the camera inside the closed box for at least one night; longer testing time may yield more reliable results.
-
Check for Photos
- If no photos are captured during the test period, the camera is working correctly.
- If photos are captured, leave the images in your gallery and reach out to us.
Still Need More Information? We’re Here to Help! Use the link below to Contact Us.